On Tuesday, 18th September 2018, all project participants were first introduced to 3D modeling. After first sketches of house models we were introduced to the program Sketchup Pro. This makes it very easy to create print templates for 3D...

On Wednesday 19th September 2018 was an introduction to microcontroller programming on the plan. Matej and the Slovakian student Marek were the responsible contact persons.As microcontroller the ESP32 was available to us. As development environment we used the Arduino...

On Thursday, the 20th September 2018 first got all project participants an introduction to soldering.Afterwards, the hardware team could start directly with the first preparations for the project.The ESP32 microcontroller was soldered to a circuit board. From this board...

The first day of our project started at 8 o'clock with breakfast at our hotel. After that we drove to the school in Banská Bystrica, where we started with a tour through the schooland an introduction to our smart...

Our day started with a great breakfast at our hotel. Then we drove to the school, where we got a introduction to the 3D modeling software SketchUp. After school we had some freetime to have lunch. Next we started...

Our day started again at 8 o'clock with breakfast at the hotel and later we went to school to keep working at our project. In the afternoon we drove to Zvolen where we started our mountain hike to the castle...

Like always we started the day with a delicious breakfast. At the school we started the day with a short introduction to soldering and later kept working in splitted groupson the smart home project. After school to the further outside located...

At the last day of the first project week, we kept working in the project groups. In the afternoon we started to a rafting tour. For that we split our group into 3 teams with 5 members each.At aroung 15...

Like every other day before we started with a good breakfast. Afterwards we drove with our buses to Donovaly, which is a well-known ski resort. At the parking lot where we arrived, we rent some bikes to start our tour,...

  After we spend the night from saturday to sunday in a hotel in Kraliky, a town not far from Banská Bystrica, wedrove back to the hotel in Tajov to have breakfast. From there we started out 2 hour drive to...

At the start of the second project week we kept working in our project teams. But because the organisation was a little bit problematic, we didnt really get forward as much as we wanted to. We had our lunch in a...

On tuesday we were highly motivated to keep working at our smart home project, because we were slowling reaching the finish line. Nearly all parts of the 3d modell were printed, circuit board was done and also the software...

Today we kept on working on the smart home project. Slowly but surely the diffrent parts came together. Around 14 o'clock we went to the city center to have lunch. Afterwards we went back to the school to finish the...

Thursday was the day that we finished the smart home project. In the morning we drove to the school for a last time. After last small tasks were finished we drove into the city centerof Banská Bystrica to have...